Power Supply Unit, PSU
12V 5A Power Adapter
MikroTik OEM power adapter with standard 5.5 / 2.1mm connector designed to power, for example, LED strips or MikroTik devices with input voltage 12V DC. The power adapter has a maximum power 60W and a maximum output current 5A. A power cord is also included with the power supply.
18V, 1A Power Supply
24V 0.8A Power Supply for use with MikroTik RouterBOARDs.
24V, 1A Power Adapter with Passive PoE Injector.
Very affordable and very popular 100Mbps passive 24V PoE injector MikroTik OEM HS24-2400 used to power most RouteBOARDs with PoE function. However, it can also be used to power other devices by supporting passive 24V PoE. The PoE injector supplies the device with free pairs of LAN cable 4,5 (+), 7,8 (-) and the total output power is 24W.
• Output Voltage: 24V
• Max Output Current: 1A
• Connector RJ45 LAN
• Connector RJ45 PoE
48V 0.75A Power Adapter
48V 1.46A 70W Power Adapter + Power plug
48V 2A Power adapter
OEM power adapter with standard 5.5 / 2.1mm connector designed to power MikroTik devices with input voltage 48V DC. The power adapter has a maximum power 96W and a maximum output current 2A. A power cord is also included with the power supply.
AD-155B - 27.6V, 5A Power Supply Unit with Battery Charger Function (UPS)
AD-155 Series 27.6V, 5A Power Supply Unit with Battery Charger Function (UPS).
AD155A - 13.8V, 10.5A - 155W Single Output with Battery Charger(UPS Function)
155W Single Output with Battery Charger(UPS Function).
DC-DC Down Convertor 5A
Onboard voltmeter auto-calibration method: 1. Onboard voltmeter shows that the output voltage, long press the right button 2 seconds to loosen, voltmeter, and the output voltage indicator light "OUT" synchronous flash, at this time into the output voltage regulation mode;Similarly, when the input voltage IN the voltmeter display, long press the right button 2 seconds to loosen, voltmeter, and the input voltage indicator light "IN" synchronous flash, at this time into the input voltage adjustment mode; 2. Touch the right key, the voltage of a unit, a light touch on the left key, voltage reduce a unit;Due to a unit of voltage is less than 0.1 V, so you need to press the 1-5 consecutive can see the voltmeter change 0.1 V, the concrete continuous button several times depends on the current display voltage, current shows that the higher the voltage, the fewer the number of pedestrian. 3. After the voltage adjustment, long press the right button for 2 seconds after the release, at this time to exit the voltage calibration mode, all the parameters set up automatic electricity saving.
ETH-SP-G2 - Ethernet Surge Protector
Introducing the Ethernet Surge Protector Gen.2, model ETH-SP-G2, from Ubiquiti Networks. The ETH-SP-G2 is a cost-effective solution for protecting outdoor Ethernet devices from damaging electrostatic discharge and surges. Since all Ubiquiti® airMAX® devices already have robust ESD protection built in, adding the ETH-SP-G2 to the installation provides an additional layer of protection to the network.
The ETH-SP-G2 is engineered to protect Power‑over‑Ethernet (PoE) or non-PoE devices with connection speeds of up to 1 Gbps. Two passive, surge-protected RJ45 connections provide maximum equipment compatibility.
